Keys, doors and windows
29
Pushing or pulling firmly and then
Windows
Keep a close watch on the
releasing: window moves up or down
windows when closing them.
fully with safety function enabled. To
Windscreen
Ensure that nothing becomes
stop movement, operate the switch
trapped in them as they move.
once more in the same direction.
Windscreen stickers
Switch on ignition to operate power
With the ignition key removed or in the
Do not attach stickers such as toll
windows.
STOP position, the windows can be
road stickers or similar on the
operated for approx. 2 minutes and
windscreen in the area of the interior
are deactivated as soon as a door is
mirror.
opened.
Manual windows
Safety function
The door windows can be opened or
If the window glass encounters
closed with the window winders.
resistance during automatic closing, it
is immediately stopped and opened
again.
Power windows
If the safety function is activated
five times in less than a minute, the
9 Warning
safety function is deactivated. The
windows will only close in stages and
Take care when operating the
Operate the switch for the respective
not automatically.
power windows. Risk of injury,
window by pushing to open or pulling
particularly to children.
Activate the window electronics by
to close.
opening the windows. The safety
If there are children on the rear
Pushing or pulling briefly: window
function is restored and the windows
seats, switch on the child safety
moves up or down in stages if the
will operate normally.
system for the power windows.
switch is held.
30
Keys, doors and windows
Overload
Child safety system for rear
If the windows are repeatedly
windows
operated within short intervals, the
window operation is disabled for
some time.
Initialising the power windows
If the windows cannot be closed
automatically (e.g. after
disconnecting the vehicle battery),
activate the window electronics as
follows:
1. Close doors.
Press and hold the Ä button to open
windows.
2. Switch on ignition.
Press and hold the e button to close
3. Pull switch until the window is
Press switch , to deactivate rear
windows.
closed and keep pulling for an
door power windows.
additional 5 seconds.
Release button to stop window
To activate, press , again.
movement.
4. Repeat for each window.
Operating windows from outside
The windows can be operated
remotely from outside the vehicle
when locking or unlocking the vehicle.
Central locking system 3 21.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Keys, doors and windows
31
A ticket holder is located on the
Rear windows
Heated rear window
backside of the sun visor.
Opening rear windows
Operated by pressing the Ü button.
Heating works with the engine
To open, move lever outwards until
running and is switched off
the window is fully open.
automatically after a short time.
To close, pull lever then push until
window is fully closed.
Sun visors
The sun visors can be folded down or
swivelled to the side to prevent
dazzling.
If the sun visors have integral mirrors,
the mirror covers should be closed
when driving.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
32
Seats, restraints
Adjustment
Seats, restraints
Head restraints
Front head restraints, height
Position
adjustment
Head restraints
32
Front seats
33
9 Warning
Rear seats
36
Only drive with the head restraint
Seat belts
38
set to the proper position.
Airbag system
41
Child restraints
47
Press the button, adjust height and
engage.
The upper edge of the head restraint
should be at upper head level. If this
is not possible for extremely tall
people, set to highest position, and
set to lowest position for small people.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Seats, restraints
33
Rear head restraints, height
■ Sit with shoulders as far back
Front seats
adjustment
against the backrest as possible.
Set the backrest to an angle so that
Seat position
it is possible to reach the steering
wheel with arms slightly bent.
9 Warning
Maintain contact between
shoulders and the backrest when
Only drive with the seat correctly
turning the steering wheel. Do not
adjusted.
tilt the backrest too far back. We
recommend a maximum angle of
approx. 25°.
■ Adjust the steering wheel 3 61.
■ Set the seat high enough to have a
clear field of vision on all sides and
on all display instruments. There
Pull the head restraint upwards or
should be at least one hand of
press the catch to release and push
clearance between head and the
the head restraint downwards.
roof frame. Thighs should rest
lightly on the seat without pressing
Removal
into it.
Rear head restraints, removal
■ Adjust the head restraint 3 32.
Press both catches, pull the head
■ Sit with buttocks as far back against
■ Adjust the height of the seat belt
restraint upwards and remove.
the backrest as possible. Adjust the
3 39.
Secure the removed head restraint in
distance between the seat and the
the load compartment.
pedals so that legs are slightly
Seat adjustment
angled when pressing the pedals.
Note
Drive only with seats and backrests
Slide the front passenger seat as
Approved accessories may only be
properly engaged.
far back as possible.
attached if the seat is not in use.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
34
Seats, restraints
Seat positioning
Seat backrests
9 Danger
Do not sit nearer than 25 cm from
the steering wheel, to permit safe
airbag deployment.
9 Warning
Never adjust seats while driving as
they could move uncontrollably.
9 Warning
Pull handle, slide seat, release
Turn handwheel. Do not lean on
Never store any objects under the
handle.
backrest when adjusting.
seats except in the underseat
storage compartment 3 54.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Seats, restraints
35
Seat height
Armrest
Heating
Lever pumping motion
Raise or lower the armrest as
Activate seat heating by pressing
up
= higher
required.
button ß for the respective front seat
down = lower
with the ignition on.
Activation is indicated by the LED in
Operate lever and adjust body weight
the button.
on seat to raise or lower it.
Pressing button ß once more
deactivates seat heating.
Prolonged use for people with
sensitive skin is not recommended.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
36
Seats, restraints
■ Secure the folded seat in the
Rear seats
upright position by attaching the
flexible cord located on the seat
frame, to the rear seat head
9 Warning
restraint.
Never adjust seats while driving as
Unfolding the seats
they could move uncontrollably.
■ To lower the rear seat, remove the
flexible cord and lower the seat
Folding the seats
assembly to the floor, ensuring the
The load compartment area can be
rear support is located on the
increased by folding up the rear
anchor point and securely latched.
seats.
■ Pull the release lever and fold down
■ Raise the backrest and adjust the
the backrest onto the seat cushion.
head restraint.
9 Warning
■ Pull the lower strap and fold the
■ The backrest is properly engaged
When folding the seat use caution
seat assembly forwards.
when the red mark on the release
- beware of moving parts. Ensure
lever is no longer visible.
the seat is secure when
completely folded.
Removing the seats
■ Remove the seat head restraint
■ Lower the head restraint and move
3 32 and remove load
the seat belt to one side.
compartment cover if necessary
■ Remove the load compartment
3 55.
cover if necessary 3 55.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Seats, restraints
37
Installing the seats
■ Raise the backrest and replace the
head restraint.
■ The backrest is properly engaged
when the red mark on the release
lever is no longer visible.
9 Warning
When installing the seat, ensure
that the seat is properly located on
the anchor points, the locking
catches are fully engaged, and the
■ With the seat folded in the upright
backrest is returned to the correct
position, push the release lever and
position.
■ Attach the seat assembly front
remove the seat assembly.
supports on the anchor points.
■ Store the head restraint on the rear
■ Push the release lever to ensure
of the seat frame.
the seat is securely latched.
■ Remove the head restraint from the
rear of the seat frame.
■ Lower the seat assembly to the
floor, ensuring the rear support is
located on the anchor point and
securely latched.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст